Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
ES Windows Driveway & Pavers: The San Antonio Owner’s Guide
A failing ES Windows driveway or paver surface in San Antonio typically runs $7,000 to $18,000 for a full paver driveway replacement, and our crews can usually start within a week of the written estimate. Most homeowners discover the problem the same way: a paver shifts underfoot near the garage apron, water pools in a low spot that wasn’t there last spring, or a section of the driveway edge crumbles after a heavy Hill Country rain.
We handle this work as a general contracting service, not as a window parts supplier. What we bring to ES Windows homeowners is the construction side: matching paver profiles and joint widths to what’s already in place, correcting the base layers that San Antonio clay soils destroy over time, and leaving a surface that drains the way it should before the next thunderstorm.
If you’re reading this, you probably already know the part that failed. A cracked bullnose paver at the driveway lip. A sunken section where the trash bins roll each week. A paver that’s spalled across the top like a popped blister. We’ll name the exact fix, price it in writing, and do the work without turning your front yard into a staging yard.
Which ES Windows Models This Applies To
ES Windows manufactures fenestration products: windows, doors, and the frame systems around them. Driveway and paver work isn’t an ES Windows product line. What usually brings an ES Windows owner to this page is a construction problem adjacent to the home: a driveway that shifted against the foundation, a paver walk that now drains toward a patio door, or a settling issue that began showing up after window replacement work changed how water runs off that side of the house.
Where ES Windows compatibility genuinely matters is clearance and flash points. If you’ve installed ES Windows impact-rated units along a garage-facing wall, the sill heights and weep systems mean the driveway grade has to fall away from the opening correctly. A paver surface that’s built too high against the sill traps water against the frame. A driveway that slopes toward the house sends runoff into the window well every time it rains. We measure from the sill, set the paver line, and write down what the final clearance will be before we touch a single stone.
The practical rule: if your ES Windows frame sits near ground level, we want the finished driveway surface at least 2 inches below the sill. That’s the clearance we set on most San Antonio paver driveways, and it’s the reason we measure every job rather than assume the existing grade is right. As an independent remodeling contractor, we don’t sell ES Windows parts or represent their product line. We build the surfaces around them to spec.
Styles & brands we work with
Signs Your ES Windows Driveway & Pavers Is Failing
- Pavers rocking underfoot. This means the bedding layer under the pavers has washed out or compressed. In San Antonio’s clay-heavy soils, this often shows up first along driveway edges where water undermines the sand setting bed.
- Spalling on paver tops. The surface flakes and pits, usually from water absorption followed by a hard freeze or sustained heat. San Antonio pavers see both: winter mornings below freezing and July afternoons above 100 degrees.
- Water pooling that wasn’t there before. A low spot means the base has settled unevenly. Left alone, it grows deeper and starts pulling water toward the garage door or a window well.
- Widening joints between pavers. Joint sand keeps pavers locked against each other. When the sand washes away, the pavers spread, and the whole surface loosens like old brickwork.
- Driveway edge crumbling or eroding. The edge is where the pavement meets the yard or the street curb. When the edge restraint fails, the outer pavers start falling away, and the damage moves inward faster than most homeowners expect.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
A paver driveway replacement in San Antonio runs $7,000 to $18,000 depending on square footage, paver choice, and how much base excavation the soil requires. Concrete driveway installation runs $4,500 to $12,000, and replacing an existing driveway runs $5,000 to $14,000. If the issue is a failing paver patio near the driveway instead, that’s $3,500 to $11,000.
Every Elmstead Remodeling San Antonio project starts with a written price, and the number doesn’t change after demo begins. That price includes the tear-out, base repair, paver or concrete installation, edge restraint, joint sand, and the clean-up, with a photo of the finished site before our crew leaves. The 365-Day Done Right Promise applies to every driveway or paver job: if something isn’t right after we’re done, we make it right.
DIY or Call Us?
You can safely check a few things yourself: look for pavers that wobble, note where water pools after rain, and measure whether the paver line has crept up against any window sills or the garage slab. That’s useful information to have ready when you call.
What we don’t recommend is pulling up and resetting pavers yourself. The failure is rarely in the paver itself; it’s in the compacted base beneath it. Lifting pavers without fixing the base guarantees the same failure within a year. Building a proper driveway base in San Antonio means excavating to stable soil, adding and compacting base material in lifts, and setting the pavers or pouring concrete with the right slope. That’s heavy, dusty, precise work, and doing it wrong only delays the job and adds cost. Call us at (432) 233-0976 and we’ll price the fix in writing before any work starts.
FAQs
A properly installed paver driveway with a correctly compacted base should hold up for 25 to 30 years in San Antonio’s climate, though the joint sand may need a top-up every few years. What kills driveways early here is water moving under the surface, so our crews spend more time on base prep and drainage than on arranging pavers. If you’re seeing failures at year eight or ten, the base was never done right in the first place. Call (432) 233-0976 for a free evaluation and a written estimate.
Yes, if the damage is localized. Paver driveways repair section by section more cleanly than concrete because individual pavers can be lifted and reset. We’ll match the existing paver profile and color as closely as the current supply allows, and we’ll tell you honestly if the base under the damaged section needs rebuilding. Often the repair is a day of work and a few hundred dollars for the pavers plus labor. Call us for an exact written quote.
Most paver driveway replacements in San Antonio take three to five working days, weather depending. Concrete driveways need about a week between pour and use, including curing time. We’ll give you a written schedule with the written price, and we’ll tell you up front when the work will be done and what the site will look like each day.
We stock common paver profiles and colors at our San Antonio yard, and we order specialty styles directly from suppliers we’ve worked with for years. If your existing pavers are a standard line, we can usually pull them same-week. If they’re an unusual color or discontinued profile, we’ll show you the closest current matches before you pay anything. And we can also write you a scope for a full paver driveway replacement if repair isn’t the right call.
Written by Graham Stein, Owner, Elmstead Remodeling San Antonio at Elmstead Remodeling San Antonio, serving San Antonio and nearby areas.
